Table of Contents
Advertisement
7. Position the shift cable into the rubber grommet and place the cable barrel
into the barrel receptacle.
a
a -
End guide
b -
Center mark
c -
Cable barrel
d -
Rubber grommet
8. Check shift cable adjustments as follows:
a. Shift the remote control into forward. The propeller shaft should be
locked in gear. If not, adjust the barrel closer to the cable guide.
b. Shift the remote control into reverse while turning the propeller. The
propeller shaft should be locked in gear. If not, adjust the barrel away
from the cable guide. Repeat steps a through c.
c. Shift the remote control back to neutral. The propeller shaft should
turn freely without drag. If not, adjust the barrel closer to the cable
guide. Repeat steps a through c.
THROTTLE CABLE INSTALLATION
Install the cables into the remote control following the instructions provided with
the remote control.
1. Position the remote control handle into full forward throttle position.
2. Attach the throttle cable end guide to the throttle lever with a washer and
cotter pin retainer.
3. Adjust the cable barrel so that the installed throttle cable will hold the lever
on the carburetor against the full throttle stop.
ENGINE INSTALLATION
b
c
120
d
32068
eng
Advertisement
Table of Contents
