Travis Industries Flush Wood Plus Owner's Manual page 13

Fireplace Insert Installation
4. Attach the sides and breastplate using the included bolts and washers, as shown below.
NOTE: After tightening the bolt, back it off ½ a turn to allow the sides and breastplate to move slightly.
5. Place the sides and breastplate near the insert. Connect the 2 rheostat wires, as shown below
(orientation does not matter).
6. Attach the sides and breastplate to the insert, making sure the two clips on each side slide over the
tabs on the insert. Make sure the front is centered on the insert.
© Travis Industries
(for qualified installers only)
100-01266_000
13
4150520