Table of Contents
Advertisement
7-47 CHASSIS
● Tighten the caliper mounting bolts ①
hose union bolt ② .
Brake caliper mounting bolt
: 18~28 N∙ ∙ m (1.8~2.8 kgf∙ ∙ m)
Brake hose union bolt
: 40~60 N∙ ∙ m (4.0~6.0 kgf∙ ∙ m)
NOTE
Before remounting the brake caliper, push the
brake caliper piston all the way into the caliper.
CAUTION
� � The removed brake hose washers should be
replaced with new ones in order to prevent
leakage of brake fluid.
� � Bleed air from the system after after reassem-
bling the brake caliper. (Refer to page 2-17)
● Install the parking brake housing ③
ket.
● Apply THREAD LOCK "1324" to the parking brake
bolts and tighten them to the specified torque.
THREAD LOCK " " 1324" "
Parking brake housing bolt
● When replacing the boot with a new one, apply
SILICONE GREASE to the groove of parking
brake axle.
SILICONE GREASE
● Loosen the lock nuts ④ , ⑥
⑤ , ⑦
in completely, so that the cable play is max-
imum.
and brake
and new gas-
: 28 N∙ ∙ m (2.8 kgf∙ ∙ m)
and turn the adjusters
①
③
④
⑤
②
⑦
⑥
Hide quick links:
Advertisement
Table of Contents
