HYOSUNG TE 450 Service Manual page 112

4-9 FUEL SYSTEM
◉ ◉ FLOAT HEIGHT ADJUSTMENT
To check the float height, turn the carburetor upside
down. Measure the float height � while the float arm
is just contacting the needle valve using a vernier
calipers.
Float height � �
Vernier calipers : 09900-20101
● Bend the float arm ①
height to the specified level.
● After adjustment, check the float height and the
fuel level again.
◉ ◉ REASSEMBLY
Carburetor reassembly can be performed in the
reverse order of disassembly. When reassembling,
carefully observe the following instructions.
● After cleaning, reinstall the pilot air jet ②
nal setting by turning the screw in until it lightly
seat, and then backing it out the same number of
turns counted during disassembly.
● Install the pilot jet ③ , jet holder ④
13 mm (0.51 in)
as necessary to bring the
to the origi-
and main jet ⑤ .
�
①
②
④ , ⑤
③