Table of Contents
Advertisement
● Align the hole ①
of the diaphragm with passage-
way on the carburetor body.
NOTE
When installing the diaphram, make sure the
diaphram is seated at the concave section of the
carburetor.
● Apply SUPER GREASE "A" to thread part of the
throttle stop screw, then install the throttle stop
screw to the carburetor.
SUPER GREASE "A"
◉ ◉ REMOUNTING
Remount the carburetor assembly in the reverse
order of removal.
Pay attention to the following points :
● Align the lug on the carburetor with intake pipe's
cutout.
● Connect the carburetor hoses properly.
● After the carburetor assembly has been remount-
ed onto the engine, perform the following adjust-
ment.
�Throttle cable adjustment.
�Idle speed adjustment.
Refer to page 2-9
∙∙
Refer to page 2-9
∙∙∙∙
①
FUEL SYSTEM 4-10
Hide quick links:
Advertisement
Table of Contents
