Table of Contents
Advertisement
◉ ◉ BRAKE PAD REPLACEMENT
● Flatten the lock washer ① , and then slightly
loosen the pad mounting pins ② .
● Loosen the lock nut ③
brake adjuster ④
several turns.
● Remove the caliper by removing the caliper
mounting bolts ⑤ .
● Remove the brake pads by removing the pad
mounting pins.
CAUTION
� � Do not operate the brake pedal while dis-
mounting the pads.
� � Replace the brake pads as a set, otherwise
braking performance will be adversely affected.
● Install the new brake pad.
NOTE
� � Before installing the new pads, inspect the pad
mounting pins for wear.
� �
If excessive wear is found, replace them with
new ones.
� � Be sure to loosen the parking brake adjuster
before installing the pads.
● Tighten the pad mounting pins ⑥
torque, and then bend the lock washer.
Rear brake pad mounting pin
: 18~28 N∙ ∙ m (1.8~2.8 kgf∙ ∙ m)
NOTE
After replacing the brake pads, pump the brake
pedal several times to check for proper brake
operation and then check the brake fluid level.
and turn out the parking
to the specified
①
②
④
③ ③ ⑥
CHASSIS 7-42
⑤
③
Hide quick links:
Advertisement
Table of Contents
