Hardware Installation - Matrox ATC Series User Manual

Hardware installation

This section describes how to install your Matrox card. For information specific to your computer,
like how to remove its cover, see your system manual.
WARNING:
it to cool before you touch any of its internal parts. Also, static electricity can severely
damage electronic parts. Before touching any electronic parts, drain static electricity from
your body (for example, by touching the metal frame of your computer). When handling
a card, carefully hold it by its edges and avoid touching its circuitry.
Open your computer and
1
remove your existing graphics
*
card
If a graphics card isn't already installed in
your computer, skip to
Using
a
Windows
currently installed display drivers.
Restart your computer for the changes
to take effect.
After your computer restarts, you're
prompted to install drivers for the new
graphics hardware detected. Click
Cancel
Turn off your computer and all peripherals such as your monitor or printer.
b
Open the computer and remove your existing graphics card. (If graphics hardware is
c
built into the motherboard of your computer, this graphics hardware should
automatically disable itself after your Matrox card is installed. For more information, see
your system manual.)
* With multi-display mode, you may be able to use your existing graphics card. For Windows 2000/XP, see Windows 2000/XP
online help under "Install additional monitors".
To avoid personal injury, turn off your computer, unplug it, and then wait for
step 2.
from the
Add/Remove program
, remove any
Control Panel
.
Matrox ATC – User Guide 3