Selecting The Media Saver; Nesting - Oce 9300 User Manual

Selecting the media saver

The Océ 9300 offers two options for optimizing usage of print media: Nesting
and Autoposition. This applies to both vector and raster formats. The media
saver can also be disabled.
The media saver is cleared in the following situations:
after a time-out
when selecting another roll or manual feed
by the flush media saver on the printer operating panel. See also 'Flush
media saver' on page 77.
When automatic roll selection is used, the media saver is inactive.
Note:
The following settings must be specified before the media saver can be used:
cut methods = synchro
center = off
leading and trailing edge = 0.

Nesting

When nesting is selected, prints are stored in queues in the printer's memory,
according to their size: 8.5x11" or A, 11x17" or B, 17x22" or C, and mixed 11
x 17"/8.5 x 11". When the queue is full, the drawings are printed across the full
width of the media.
The minimum paper length is 16.5 inches. Therefore, when printing 11 x 17"
landscape or 8.5 x 11", an extra strip of white paper appears at the end.
If the print is larger than C size, it will not be stored in a queue but will be
printed normally. If prints are not standard ISO, ANSI or Architecture sizes,
the next larger format is used (see figure 23 on page 75).
Selecting nesting
Press 'Program' to enter the main menu.
1
Select the 'C
2
Press 'next/select' to enter the 'C
3
Select the '
4
Press 'next/select' to enter the '
5
74 Océ 9300 User Manual
' item using the
ONFIGURATION
' item using the
PLOT MANAGER
or
' menu.
ONFIGURATION
or
' menu.
PLOT MANAGER
button.
button.