Installing & Adjusting The Upper Rack - Labconco SteamScrubber 44003 Series Service – Technical Manual

Labconco Glassware Washer Service/Technical Manual
Modifications
Installing (FlaskScrubber®) & Adjusting the Upper Rack
The Upper Rack comes standard on the SteamScrubber®; however, the
FlaskScrubber® has the option of adding the Upper Rack (Spindle or Basket).
The Optional Upper Spindle Rack provides 30 additional spindles for washing
narrow-neck glassware and is customizable by removing spindles or by
installing Multi-Pin Inserts. The Open Basket allows for the washing of open
mouthed glassware.
heights of glassware that will be washed in the upper and lower racks.
Installing the Upper Rack
The optional upper racks for FlaskScrubbers® ship with two (2) each Slide
Assemblies and Mounting Bracket Assemblies (See Figure below).
1. Remove the acorn nuts and lock washers from both upper sides using a
3/8" wrench.
2. Position brackets on slides over the studs on the sides.
of the rack mounting plates must be as shown.
assemblies using lock washers and acorn nuts removed in Step 1.
be necessary to synchronize the travel of the two slides.*
3. Install the Upper Spindle Rack by lowering the rack onto the rack
mounting plates.
Make sure the latch on each side secures the rack to the rack mounting
plate.
14
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
The height of the upper rack may be varied to suit the
There are 4 on each side.
The water inlet must have its inlet toward the rear.
The position
Secure the slide
It may