Adjusting The Door Latch Keeper Strike Plate; Replacing The Washer Light Bulb - Labconco SteamScrubber 44003 Series Service – Technical Manual

Adjusting the Door Latch Keeper Strike Plate

If, when the door is closed and latched, the latch is loose, or the
machine turns off during a cycle due to vibration or bumping, then you
may need to adjust the Door Latch Keeper/Strike Plate.
Adjusting the Door Latch Keeper/Strike Plate
1. Open the door to the glassware washer.
2. Loosen the two screws indicated by the Red Arrows.
3. To tighten the latching action of the Door Latch, move the plate in the
direction of the Blue Arrow.
4. To loosen the latching action of the Door Latch, move the plate in the
direction of the Yellow Arrow.
NOTE: If this fails to correct the problem, perform electrical
troubleshooting on the Door Switch (located behind the plastic Control
Panel). The Door Switch Assembly may need to be replaced.

Replacing the Washer Light Bulb

If the Glassware washer is equipped with a window, you will need to
periodically replace the light bulb.
the instructions to replace the washer light bulb.
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
Labconco Glassware Washer Service/Technical Manual
Refer to the figure below and follow
11