Maintaining The Tap Water Fill Valve; Cleaning The Sump Filter Screen - Labconco SteamScrubber 44003 Series Service – Technical Manual

Maintaining the Water Fill Valve
The filter screen of the water fill valve, illustrated below, may
require periodic cleaning to remove trapped particles.
fill occurs if the blockage is not removed.
To Clean the Water fill valve
1. Turn off the water and electrical power to the washer.
Mobile model; turn off the circuit breaker that services the Under-
Counter or Freestanding model.
2. Remove the rear panel of Free-Standing models.
3. Disconnect the water supply tube that is connected to the valve.
4. Remove the valve from the base.
5. Remove the four screws from the valve plate and separate the valve from
the inlet connection.
6. Remove the valve filter screen and clean it under running water
7. Replace the screen and reassemble the valve connection.
O-ring gasket is positioned in the groove in the fill valve body.

Cleaning the Sump Filter Screen

If debris has accumulated on the filter screen (located in the washer
sump), you can remove and clean the screen.
screen, refer to the figure and instructions below.
To clean the sump filter screen
1. Open the washer door and remove the bottom rack.
2. Remove the screw that retains the filter screen.
3. Carefully lift the screen and pull forward, using care not to drop
debris into the sump.*
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
Labconco Glassware Washer Service/Technical Manual
A low water
Unplug the
Be certain the
To clean the sump filter
9