Table of Contents
Advertisement
HWC_GSG_ConfiguringExternalServers.fm
Configuring DHCP, DNS and IAS services
DHCP service configuration
62
To configure DHCP in Window 2003 Server:
1. Click Start, point to Administrative Tool, and then click DHCP.
2. In the console tree, right-click the DHCP server on which you want to create
the new DHCP scope, and then click New Scope.
3. Click Next. The Scope Name window is displayed.
4. In the Name and Description text boxes, type the scope's name and the
description respectively.
This can be any name that you want, but it should be descriptive enough so
that you can identify the purpose of the scope on your network.
5. Click Next. The IP Address Range window is displayed.
6. In the Start IP address and the End IP address text boxes, type the start and
end of the IP addresses' range that you want to be distributed to the network.
Range – Is the range of addresses that the scope will distribute across the
network. You must use the range provided by your network administrator.
7. In the Length text box, type the numeric value of the subnet mask's bits; or
in the Subnet mask text box, type the subnet mask's IP address.
120385-00 Rev 01, March 2007
Summit WM, Getting Started Guide
Advertisement
Table of Contents
