Extreme Networks Summit WM100 Getting Started Manual page 31

Configuration data Description
Local DHCP • Gateway – The Summit WM Switch advertises this address to the
Server In Routed
WM-AD
• Subnet mask – Subnet mask for the gateway IP address to
• Address range – The range from which the IP addresses are
• External enterprise domain name – The external enterprise
• DNS Server IP address– The IP address of the domain name
DHCP Relay in • Gateway – The Summit WM Switch advertises this address to the
Routed WM-AD
• Subnet mask – Subnet mask for the gateway IP address to
• DHCP Server IP address(es) – IP addresses of the external
Next Hop Routing • Next hop IP address – The next-hop IP identifies the target
for Routed WM-
AD
• OSPF routing cost – The OSPF cost value provides a relative
VLAN Information • VLAN ID – The ID # of VLAN that is mapped to a Summit WM
for Bridge Traffic
Locally at SWM • Interface – The name of the interface to which the VLAN is
WM-AD
• Interface IP address – The interface's IP address.
• Mask – The subnet mask of the WM-AD.
VLAN ID for • VLAN ID – The ID #of VLAN that is mapped to a Summit WM
Bridge traffic
locally at WAP
WM-AD
Table 4 Information gathering table
120385-00 Rev 01, March 2007
Summit WM, Getting Started Guide
wireless devices when they sign on and get a dynamic IP address.
The gateway corresponds to the IP address that is communicated
to mobile users.
separate the network portion from the host portion of the address
(typically 255.255.255.0).
provided to the wireless devices that use the WM-AD.
domain name.
server on the enterprise network.
wireless devices when they sign on and get a dynamic IP address.
The gateway corresponds to the IP address that is communicated
to mobile users.
separate the network portion from the host portion of the address
(typically 255.255.255.0).
DHCP servers on the enterprise network.
device to which all WM-AD (user traffic) will be forwarded to. Next-
hop definition supersedes any other possible definition in the
routing table.
cost indication to allow upstream routers to calculate whether or
not to use the Summit WM Switch as a better fit, or lowest cost
path to reach the devices in a particular network. The higher the
cost, the less likely that the Summit WM Switch will be chosen as
a route for traffic, unless that Summit WM Switch is the only
possible route for that traffic
Switch interface.
mapped.
Switch interface.
HWC_GSG_Chapter 1_Overview.fm
Summit WM-Series WLAN Switch Software Solution
Collecting information for installation
Your entry
31