Table of Contents
Advertisement
Configuration data Description
WPA-PSK privacy
• Broadcast re-key interval – The time interval (in seconds) after
information
• Pre-shared Key – The shared secret key that is to be used
The shared secret key is used to generate the 256 bit key.
Dynamic WEP
Broadcast re-key interval – The time interval (in seconds) after
privacy
which you want the broadcast encryption key to be changed
information
automatically. The default is 3600.
Availability
• Primary Summit WM Switch's IP address
information
• Secondary Summit WM Switch's IP address
• IP address of primary Summit WM Switch's physical port
• IP address of secondary Summit WM Switch's physical port
Mobility manager
• Port – The interface of the Summit WM Switch that is to be used
information
• Heartbeat – The time interval (in seconds) at which the mobility
Mobility agent
• Port – The interface of the Summit WM Switch that is to be used
information
• Heartbeat – The time interval (in seconds) for which the mobility
• Discovery Method – The method by which the mobility agent will
Table 4
Information gathering table
120385-00 Rev 01, March 2007
Summit WM, Getting Started Guide
which you want the broadcast encryption key to be changed
automatically. The default is 3600.
between the wireless device and the Altitude AP.
as the mobility manager. Ensure that the selected interface is
routable on the network.
manager sends a heartbeat message to the agent. The default is
5.
as the mobility agent.
Ensure that the selected interface is routable on the network.
agent should wait for the connection establishment response
before trying again. The default is 60.
discover the mobility manager. You have the following two options:
•
SLPD (Service Location Protocol Daemon) – Enables the
discovery of mobility manager Summit WM Switch, using
SLP. The mobility manager's address must be configured on
the network using SLP when selecting this option.
•
Static Configuration – Allows the mobility agent to discover
the mobility manager without the SLP support. If you select
Static Configuration, you will need the IP address of the
Summit WM Switch that will serve as the mobility manager.
HWC_GSG_Chapter 1_Overview.fm
Summit WM-Series WLAN Switch Software Solution
Collecting information for installation
Your entry
33
Advertisement
Table of Contents
