Table of Contents
Advertisement
8.4 Creating and configuring a Bridge Traffic Locally At WAP WM-AD
120385-00 Rev 01, March 2007
Summit WM, Getting Started Guide
Creating and configuring a Bridge Traffic Locally At WAP WM-AD
•
DHCP Option – Provides you the option of either using the external
DHCP server or the local DHCP server on the Summit WM Switch. For
more information, see Step #
AD.
•
VLAN ID – The ID #of VLAN that is mapped to a Summit WM Switch
interface.
•
Interface – The name of the interface to which the VLAN is mapped.
•
Interface IP address – The interface's IP address.
•
Mask – The subnet mask of the WM-AD.
5. From the Network Assignment drop-down list, click the network
assignment. For more information on network assignment, see "Step #
Creating and configuring Routed WM-AD".
6. Type the values in the following three Timeout text boxes – Idle (Pre), Idle
(Post), and Session. For more information on Timeout text boxes, see "Step
#
7
of Creating and configuring Routed WM-AD".
7. To save your changes, click Save.
As a next step, you must configure the authentication mechanism for the WM-AD.
For more information, see
for
WM-AD".
This configuration enables the WM-AD to provide branch office mode. The VLAN
ID for the branch office is assigned by the office network administrator. The
Altitude AP will operate correctly only when the VLAN ID is unique per AP.
To configure a Bridge traffic locally at AP WM-AD:
1. From the main menu, click WM Access Domain Configuration. The WM
Access Domain Configuration screen is displayed.
2. In the Add subnet text box, located in the lower portion of the left pane, type
the WM-AD name.
3. Click Add subnet. The name is displayed in the virtual networks list and the
Topology tab is displayed.
4. From the WM-AD Mode drop-down list, click Bridge Traffic Locally At
APWAP. The VLAN Setting text boxes are displayed.
5. To define the VLAN setting, select one of the following:
•
Tagged – If you select Tagged, type the VLAN ID in VLAN ID text box.
The default value is 1.
HWC_GSG_VNSConfiguration.fm
5
of Creating and configuring "Routed" WM-
Section 8.5, "Configuring authentication mechanism
WM-AD configuration
6
of
101
Advertisement
Table of Contents
