HWC_GSG_Avail&MobilConfiguration.fm
Availability and Mobility configuration
Configuring availability feature
126
1. Login on both the Summit WM Switches.
2. From the main menu of the primary Summit WM Switch, click Altitude AP
Configuration. The Altitude AP Configuration screen is displayed.
3. In the left pane, click WAP. The WAP screen is displayed.
4. In the Registration Mode section, click Stand-alone.
5. In the Security Mode section, click Allow only approved Altitude APs to
connect.
6. From the main menu of the secondary Summit WM Switch, click Altitude AP
Configuration. The Altitude AP Configuration screen is displayed.
7. Repeat Step 3 to Step 5.
8. From the main menu of the primary Summit WM Switch, click Altitude AP
Configuration. The Altitude AP Configuration screen is displayed.
9. In the left menu, click Access Approval. The Access Approval screen is
displayed.
10. Check the status of every Altitude AP and approve all those that should be
connected to the primary Summit WM Switch.
Note: You must delete all such Altitude APs that are in pending state and you do not
intend to approve them.
120385-00 Rev 01, March 2007
Summit WM, Getting Started Guide