Pressing In - Hettich BlueMax Mini Typ 3 Operating Manual

Operation

Pressing in

1. Clip hinge with premounted sockets into the insertion die
for hinges and clip hinge arm in between the retaining
springs.
Fig. 35: Insertion die
2. Move down catch with hinge insertion die as far as the stop
over the drill hole.
en
Fig. 36: Insertion die for hinges
68
3. Initiate the insertion process by pressing manually
operated valve 1 and terminate by letting it go again.
Move up the hinge insertion die. Release hold-down clamp
using lower momentary switch
Remove workpiece.
Fig. 37: Manually operated valve and momentary switch
.
2
1
2