8 routes at length 32
Route origin distribution:
10 routes from Direct 8 routes from Host
Layer 2 and Layer 3 Switching Attributes
The ARM relies on the MSM switch fabric to support the layer 2 switching
functions.
If Destination Sensitive Accounting is enabled, the switch fabric hardware does not
perform layer 3 switching for any protocols. The ARM performs layer 3 forwarding the
IP.
All of the IP routing protocols are supported: RIP, OSPF, BGP, DVMRP, PIM.
IPX routing is not supported when Destination Sensitive Accounting is enabled.
Jumbo Ethernet frames are supported by the ARM.
Server Load Balancing (SLB) feature is not supported by the ARM.
Debug Trace Commands
System-level debug tracing is provided for the accounting subsystem. To enable this
support, use the following command:
config debug-trace accounting <level>
System-level debug tracing is provided for the Network Processor card (npcard)
subsystem. To enable this support, use the following command:
config debug-trace npcard <level>
The debug commands should be used only under the guidance of Extreme
Networks technical personnel.
In general, the "level" maps the severity of the log message. Table 3-10 displays the
definitions for the npcard subsystem.
Accounting and Routing Module Installation and User Guide
Additional ARM Support Topics
3-29