Route Map Examples - Extreme Networks BlackDiamond 6800 Installation And User Manual

When there are multiple match statements, the primitive match-one or match-all in the
entry determines how many matches are required for success. When an entry has no
match statements, the entry is considered a successful match.
Configuring the Accounting Bin Number for Route Map Entry
To configure an accounting bin number associated with a specified route map entry, use
the following command:
config route-map <route-map> <sequence_number> [add | delete] set
accounting-index 1 value <bin_number>
Where the following is true:
• The
route-map
• The
sequence_number
sequence number must be associated with a match statement.
• The
set accounting-index 1 value
parameter is an accounting bin number.
• The
bin_number
accounting bin number.

Route Map Examples

Destination Sensitive Accounting uses the
to map traffic destinations to accounting bins. Access profiles are applied to route maps.
Route maps are applied to the routing table to count traffic. Traffic is counted in eight
different bins per VLAN. See the ExtremeWare Software User Guide for more information.
Configuring Destination Sensitive Accounting Based on Destination IP
Subnets
In this example, all IP unicast traffic is forwarded by the BlackDiamond switch to one of
three IP subnets. Each IP subnet is mapped to a different accounting bin. The steps that
follow describe how to configure the accounting feature. This example assumes that the
VLANs are created, IP forwarding is enabled, and accounting is enabled.
1 Create access profiles for each destination subnet. The following commands create
three different profiles: arm1, arm2, and arm3. Each profile is defined to be type
ipaddress
create access-profile arm1 type ipaddress
Accounting and Routing Module Installation and User Guide
parameter identifies a particular route map.
parameter identifies a specific entry in that route map. The
parameter is an integer between 0—7, and allows you to define the
with a mode of . Each subnet is then assigned to one of the profiles.
none
keyword phrase indicates that the following
and
access-profile
Using Route Maps
commands
route-map
3-15