As Required; Cleaning The Machine; Cleaning The Water Sprinkling System - Fayat Bomag BP 25/50 Operating Instruction, Maintenance Instruction

8.10

As required

8.10.1

Cleaning the machine

8.10.2

Cleaning the water sprinkling system

Fig. 86
NOTICE!
Danger of engine damage caused by reduced
cooling!
– Immediately seal any oil or fuel leaks near fuel
tank, cylinder or cooling air intake.
1. Park the machine in secured condition
the machine in secured condition.' on page 56.
2. Allow the engine to cool down for at least 30 minutes.
NOTICE!
Components can be damaged by water entering
into the system!
– Do not direct the water jet directly into the air filter,
carburettor, recoil starter, air intake or starter
switch.
3. Clean the machine with a water jet.
4. Run the engine warm for a while to avoid corrosion.
1. Remove the locking cap (2).
2. Pull the hose (3) off the water tank.
3. Open the rotary knob (1) completely and let all water run out.
Alternatively you may also remove the water tank
for cleaning.
4. Flush the water tank with a strong water jet, until all dirt has
run out.
5. Connect the hose to the water tank again.
6. Fill the water tank with clean water and close the locking cap.
BP 25/50
Maintenance – As required
Ä Chapter 6.5 'Park
89