Fayat Bomag BP 25/50 Operating Instruction, Maintenance Instruction page 51

Fig. 29
Fig. 30
8. Guide the starter handle back to initial position by hand.
9. If the engine does not start during the first attempt, repeat the
starting process.
10. Open the choke bit by bit when the engine is running.
11. Set the throttle lever to position "MIN" and let the engine run
at idle speed to warm up for 1 to 2 minutes.
NOTICE!
Danger of engine damage!
– Run the engine warm for a short while before
starting work. Do not operate the engine
immediately under full load.
ð Operation of the machine can be started as soon as the
engine responds to short throttle commands.
12. Should the engine stop again after approx. 3 to 5 seconds:
n Close the choke again.
n Repeat the starting procedure.
If the recoil starter is frequently operated with the
choke closed, the engine will draw in too much fuel
and is unable to start
engine has flooded' on page 97.
BP 25/50
Operation – Start the engine
Ä Chapter 9.3 'What to do if the
53