Advertisement
2.1.3.1 Global Settings
To place the unit
into the "Dealer Mode" for adiing tha global settings, do the following:
1. While pressing and hilding the [lAMPI and [ 0] buttons, switch the power 'on". After 2
seconds the radio enters the dealer moda and
2. While in dealer mode, press [o] to enter the Global Settings mode.
Table 2.3 shows the function number and function options that can be selected while in this
mode. While in this mode, the Channel Selector knob is used to set functions "ON" or "OFF" or
to select the setting. After a function is sat, pressing the [PlTl button stores the setting and
increments the menu to the next function option. Also, when the [PlTj button is pushed, a
beep will sound to confirm the setting.
Pressing the [o] button at any time while reviewing the function options will pause the unit to
exit the selection mode and revert back to the dealer mode screen. The current function option
will not be stored if it was changed. After the complete option list has been cycled through,
"End" will appear on the display. To exit dealer mode, cycle the power "off' and then back 'ona.
To review or confinn the function settings while in the Global Settings mode,
the [MONI] buttun and turn the channelelect knob.
Monitor Momentary
MONITOR
[ S E - : ]
Disables the [MONI] button.
Signaling squelch (CTCSS, CDCSS, 2-Tone, or
DTMF) is temporarily disabled when the MONI
button is pressed.
Toggles between signal squelch and monitor
display.
.
and hold
press
Page?
Advertisement
