Advertisement
Table 2.1 shows the functions that can be sat for each of the "Dealer Modes". The dealer sets
the operations functions, channel frequencies, signal modes in accordance to the customer's
software before the dealer programming mode can be accessed.
Table 2.1 - Dealer M=,-
2.1.2
Dealer Ydes - Quick Referwtce
Place the unit in the programming mode by pressing and holding the [LAMP] and [ 0 J buttons,
switch the power "on". After 2 seconds the radio enters the dealer mode and "SEL" appears on
the display.
While in dealer mode, press the respective soft function key for the mode to be programmed.
See Table 2.2.
Page 6
Channel 8. Look Back A 0. Look Back B 10. Revert Channel 11 .TX Scan Delay
Time 12. Dropout Delay Time 13.Time Out Timer 14. Transmit Waning 15.
TOT Resume Time 18. TOT Reset Time 17. Squelch Level 18. Beep
Time Wii CTCSS 20. PTT ID 30. Dial ID 31. Connect ID 32. Disconnect ID 33.
No. Gf DTMF Keys 34. DTMF Hold Time 35. Store 8 Send 38.D Key
Assignment 37, DTMF Signaling 38. Intermediate Code 30. Group Code 40. SQ.
4 5 .
Tone
48.
Tone Duration 47. Channel
Group 40. Sofl Group Key 2 [o]
I. Channel Selection 2. RX Frequency 3. RX Tone Signaling 4. TX Frequency 5.
TX Tone Signaling 8. DTMF&Tone Signaling 7. ANI ID Enable 8.Scan
ln this mode, data is copied from one radio to another without cable by means
editing
Label Size 48. Soft Key 1
3 [a] Assignment 51.
RELM Communications
Advertisement
