Advertisement
Cloning allows the memory contents of one unit (source) to be transferred to another unit
(target). There are twu mathods that can be usad for cloning tha RPV5gg sarias radii.
.
Wired - Cloning using tha CCRP cloning cable.
l
2. Connect each end of tha CCRP cable into the respective micmphone jacks of the radii.
3. Turn tha taqet unit 'on".
Do the following with the souma radii:
4. While pressing and holding the [LAMP] and
seconds tha radio enters the dealer mode
and "SEL" appears on the display.
5. Press the [LAMP] button to enter the done
mode. "-c-' will appear in the display.
6. Press the WONI] button to transmit the
data to the target unit. While the data is
the target unit and the busy icon on the
display will flash. When the transfer is
complete. Both displays will show "END".
7. To done another target unit turn off the target unit, remove the CCRP cable from the
target unit, connect the CCRP to another target unit, and switch the unit on.
8. Press the [LAMP] button on the sourca unit, "SEL" appears on the display.
9. Repeat steps 5 and 6 to done more units.
Due to the length of the transmission for the transfer, the wireless
doning process is performed with two separate data transfers
(first 0% - 50% and second 50% - 100%)
1. Remove the antenna.
2. while prassing and holding the [LAMP] and [O] buttons,
switch the power "on". After 2 seconds the radio enters
the dealer mode and "SEL" appears on the display.
Target Display
source Display
Target Display
1
1
Page 23
Advertisement
