Advertisement
3. Pressthc
A freqw
b to ac&rst the freqwwy to the desii
to receive data on. Note: Pressing the [LAMP]
in 1 MHz steps.
4. While pn
power UonD. After 2 seconds the radio enters
the desk
mode and "SEL" appears on the display.
5. Press the
A frequel
b to adjust the frequency to the desired
select kn
to transmit data on. Note: Pressing the [LAMP]
button WI
in 1 MHz steps.
8. Press thr
PTT button to start cloning the first half (0% -
50%) of 1
e data. '00 CLONE" will appear in the displays
of both tl
icon will I
icon will I
indicator
ED indicator will be green (indicating receiving).
During cl
ning, the two-digit counter will increment one
digit at a
me on each of the displays.
When clonin
is successful, "END" will be shown on the displays. If "ERROR" is shown on
the target3 c
charged and
hat the source and target units are in close proximity to each other.
7. Allow the
ransmitter to rest (cool down) for approximately 1 - 3 minutes before starting
the sect01
[LAMP] button to continue cloning the second half (50% - 100%) of the data.
8. Pressthr
r icon will be displayed on the souse unit and the receiver icon will be
on the target unit The source's LED indicator will be red (indicating
transmitti
g) and the target's LED indicator will be green (indicating receiving). During
cloning, 1
When cloning is
target's display,
tart the cloning process over. Make sure the batteries are fully charged and
ning by Computer
Programming a
for the programming cable (PCRP) and software (RESRPW).
Page 24
Source Display
Advertisement
