Advertisement
Table 2.7 - Dealer Mode Channel Settings
Any tone frequency between 67.0 Hz and 250.3 Hz can be programmed into the RP599APlus
Frequencies shown in table 2.8.
Table 2.8 - CTCSS Frequencies
Also, the
Page 20
is less than +I-2.5Kl-L
'ID' will flash one time if DTMF signaling has been
selected. The DTMF code must have a minimum of 3
digits, but no more than 10 digits. If more than 8 digits
are used, the display will scroll.
A tone from 280 Hz to 3500 Hz in 1 Hz increments can
be used for 2-Tone signaling. The tone sets in the TTS
table (I-16 tone sets) can be edited by using the PC
editor (RESRPQQPlus)
change has been made to the TTS table, then only
defaults can be selected from Table 2.10.
A tone from 280 Hz to 3500 Hz in 1 Hz increments can
be used for 2-Tone signaling. The tone sets in the TTS
table (l-16 tone sets) can be edited by using the PC
editor (RESRPQQPIus)
chenae has been made to the TTS table. then onlv
defaults can be selected from Table 2.16.
'CH LABEL" will flash once prior to label entry mode. See
Table 2.11 for all the possible characters and character
I\
I
key
and PC cable (PCRP). If no
and PC cable (PCRP). If no
assignment.
RELM Communications
and transmit deviation
Advertisement
