Advertisement
2. [SCN]
Il. Dwell Time
12. Dropout Delay Time
14. TOT Pm-Alert
15. TOT Rekey Time
31. Connect ID
To place the unit into the "Deafer Mode" for editing the enhanced globa! settings, do the
following:
1. While pressing and holding the (LAMP] and [O] buttons, switch the power %n". After 2
seconds the radio enters the dealer mode and "SEL" appears on the display.
2 . While in dealer mode, press [a] to enter the Enhanced Global Settings mode.
Table 2.6 shows the function options that can be selected while in this mode. While in this
mode, the Channel Selector knob is used to set functions "ON" or 'OFF" or to select the
setting. After a function is
menu to the next function option. Also, when the [PllJ button is pushed, a beep will sound to
confirm the setting.
Pressing the [o] button at any time while reviewing the function options will cause the unit to
exit the selection mode and revert back to the dealer mode screen. The current function option
will not be stored if it was changed. After the complete option list has been cycled through,
"End" will appear on the display. To exit dealer mode, cycle the power "off' and then back 'on".
RELM Communications
DTMF
T O
Fiied, Selected
Priority, Priority + Selected
set, pressing the
37. DTMF sianalina is OFF
I 7. Prioritv is fixed or selected.
2. [SCN] is OFF
6. Priority is OFF or fixed.
6. Priority is OFF
6. Priority is OFF
6. Priority is OFF
I
13. Time Out Time is OFF
I
13. Time Out Time is OFF
13. Time Out Time is OFF
29. PlT ID is OFF or disconnected and 30. Dial ID is
37. DTMF signaling is OFF or is code SQ.
37. DTMF signaling is OFF.
37. DTMF signaling is OFF.
stores the setting and increments the
button
I
I
I
I
I
Page 15
Advertisement
