Advertisement
DTMF Settings
To place the unit into the 'Dealer Mode' for ediing the DTMF settings, do the following:
1. While pressing and holding the (LAMP] and [O] buttons, switch the power "on". After 2
seconds the radio enters the dealer mode and "SEL" appears on the display.
2 . While in dealer mode, press [O] to enter the DTMF Settings mode.
Table 2.4 shows the function number and function options that can be selected while in this
mode. while in this mode, the Channel Selector knob and keypad (O-9, *, #, A-D) are used to
set DTMF functions 'ON" or MOFF or to select the setting. After a function is set, pressing the
whsn the [purl button is pushed, a beep will sound to confirm the setting.
Pressing the [O] button at any time while reviewing the function options will cause the unit to
will not be stored lf it was changed. After tha completa option list has been cycled through,
To review or confirm the function settings while in the DTMF Settings mode, press and hold the
transmit delay time should be set * 300 ms.
Communications
(1 Oms steps)
1 OOms-1OOOms
RISE 100
steps)
RISE 1000
RTQT 100
(50ms steps)
RTQT 1000
The period of time that each of the
programmed DTMF ANI digits
transmitted.
The period of time between each of the
programmed DTMF ANI digits
The period of time that the first digit of
the programmed DTMF ANI is
transmitted.
of time between un-
modulated TX carrier and when the
CTCSS is transmitted.
are
Page 11
Advertisement
