Table of Contents
Advertisement
GPS:GPS Position Annunciation (Optional)
The radio can annunciate the information of the current position
such as longitude and latitude through the microphone when the
programmed key "GPS Position Annunciation"is pressed. (If the
radio cannot locate its position, then it will annunciate "un-
positioned").
GPS ID：GPS ID Annunciation (Optional)
The radio can annunciate the ID number through the microphone
when the programmed key "GPS ID Annunciation"is pressed.
GPS：GPS Time Annunciation (Optional)
The radio can annunciate the current time when the programmed
key "GPS Time Annunciation" is pressed. (The time zone can be
set by the dealer; if the radio cannot discover the position, then it
will annunciate "un-positioned".
■VOX (Voice Operated Transmission)
VOX allows hands-free transmission on the radio when using the
appropriate earphone/headset.
Two types of VOX are available: built-in and external.
If VOX has been set, when speaking voice reach the preset
volume, VOX will activate the radio to transmit automatically.
■Wired Cloning Mode
To enter the clone mode, wired cloning function should be set on
both host and sub radio.
Wired cloning procedures are as follows:
1) Press and hold the Side Button 1 and 2 on the host radio while
turning on the radio; about 2 seconds later, orange indicator flashes
13
twice and the radio enters cloning mode.
2) Press once the PTT button on the host radio, and then the sub
radio to receive data will enter Wired Cloning Mode.
3) In the cloning mode, the host radio lights red indicator and the
sub radio lights green indicator.
Note:
During the course of cloning, if the radio models or software
versions doesn't match, the host radio flashes red indicator (0.25s
On 0.25s Off), and the sub radio restart; if no data is transferred,
the host radio flashes red indicator (0.25s On 0.25s Off), and the
sub radio restart.
■
RADIO SETTING
TOT (Time-out Timer)
1) TOT (Time-out Timer)
A) Time-out timer is to prevent any caller from occupying one
certain channel and radio transmitting overlong.
b) You can program the time-out timer, i.e. the time the radio can
transmit continuously. If the radio has been transmitting
continuously longer than the preset time, the radio will stop
transmitting and warning tone sounds, and please release the PTT
button.
2) TOT Re-key
a) TOT re-key specifies the time when transmission is prohibited
after the time-out timer is activated.
b) During the time of transmitting prohibition, if you press the PTT
button, warning tone sounds and transmitting is prohibited.
3) TOT Pre-alert
14
Advertisement
Table of Contents
