Advertisement
LBB 500
LBB 5000
REV SEL
REV LSTU
Last used
SEL TALK
Selected * Talk Back
Priority
REV PRIO
Priority + Talk Back
PRI TALK
TSDT 0.5
(0.5s steps)
TSDT 5.0
DODT 0.5
DODT 5.0
Conditions: 1. The priority feature is enabled. 2.
The Scan feature is enabled. 3. The radio is in the
scan mode. 4. The radio stops on an active
channel that is not the priority channel. 5. A signal
is detected on the priority channel, but the
signaling squelch (CTCSS, CDCSS, ~-TOM?,
DTMF) is not the same as the priority channel.
Look Back B is the time intervals that the priority
is checked for activity while receiving on the non-
priority channel.
Starts scanning or resumes scanning from the
selected channel. When scanning and the PlT
button is pressed, it will transmit on the last
channel to be selected by the channel selector
even if a call is being received on another
channel.
Starts scanning or resumes scanning from the last
channel that received a call. When scanning and
the PTT button is pressed, it will transmit on the
last channel that received a call.
Starts scanning or resumes scanning from the last
channel that was transmitted on. When scanning
and the PlT button is pressed, it will transmit on
the last channel that was transmitted on even if a
call is being received on another channel.
Starts scanning or resumes scan from the
selected channel. When scanning and the PTT
button is pressed, it will transmit on the last
channel to be selected by the channel selector; or
if a call is received and the Pll' button is pressed,
it will transmit on the received channel (the PlT
must be pressed before the Drop Out Delay Time
ends, othewise it will transmit on the last channel
selected).
Starts scanning or resumes scanning from the
priority channel. When scanning and the PlT
button is pressed, it will only transmit on the
priority channel. When in the manual mode, the
radio will transmit on the selected channel.
Starts scanning or resumes scanning from the
priority channel. When scanning and the PTT
button is pressed, it will transmit on the priority
channel; or if a call is received on a non-priority
channel and the PTT button is pressed, it will
transmit on the received channel (the PTT must
be pressed before the Drop Out Delay Time ends,
otherwise it will transmit on the priority channel).
The period of time that the radio stays on a
channel after a transmission has been made
before it resumes scanning.
The period of time before the radio resumes
scanning after a received channel becomes
inactive.
or
Page 9
Advertisement
