Table of Contents
Advertisement
a) Before the time-out timer stops transmitting, the radio sounds
pre-alert tone.
b) After the alarm tone, if the transmitting time is longer than the
preset time limit, the time-out timer will be activated.
4) TOT Reset
a) TOT Reset is the delay time between releasing the PTT button
and resetting the time-out timer.
b) If the time of releasing the PTT button is shorter than the TOT
Reset, the countdown of transmitting prohibition will continue.
Battery Save
The dealer can program the battery save type.
If the battery save function has been set, 10 seconds after no
signals being received or no operations being conducted, the radio
enters the battery save mode. It will exit the battery save mode
automatically after receiving signals or being conducted.
Battery Save Types: 1:1, 1:2, 1:4 and OFF.
Battery save function can decrease the battery power
consumption.
Low Power Warning
Low power warning tone sounds and LED flashes when the
battery power goes below the preset value and you need to
recharge the battery. In very low battery status transmission is
prohibited.
Channel Annunciation
The dealer can activate or prohibit this function. Two types of
Chinese and English annunciation are available.
When switching to a channel by rotating the channel knob, the
15
current channel number will sound.
CTCSS/DCS
The dealer can set CTCSS/DCS on the radio channels to ignore
calls on the same channel from irrelevant radios.
Note:
Using a CTCSS/DCS channel doesn't mean your calls are private.
If the CTCSS/DCS tones of other radios are identical with those
on yours, they can hear your calls.
■
User Template
A user template includes PTT code-transmitting, encoding,
decoding, Busy Channel Lockout, Call 1/2/3/4, RX squelch mode,
TX conditions and decoding conditions, etc. Maximum 16 user
templates are available on this radio.
RX Squelch Mode
The dealer can set conditions under which the speaker will be
activated from the following 4 options:
1) CTCSS/DCS and Audio Squelch: The speaker will be activated
only when both CTCSS/DCS and the selective Signallings match.
2) Audio Squelch: The speaker will be activated when the
selective Signallings match.
3) CTCSS/DCS Squelch: The speaker will be activated when
CTCSS/DCS match.
4) Carrier Squelch: The speaker will be activated when carrier
wave presents
DTMF
16
Advertisement
Table of Contents
