Message Frame Type - Siemens SIMOTION ADI4 Equipment Manual

Note
PROFIBUS address 127
If PROFIBUS address is set to 127, when the module powers up, the firmware release is displayed
on the internal module LEDs using a flashing code. It is not recommended to use PROFIBUS
address 127 as this lengthens the time that the module requires to power up.
After the dialog is confirmed with "OK", the "DP Slave Properties" dialog box is opened. Continue
with the parameter assignment for the message frame type.
4.4.3

Message frame type

Telegram type
The ADI4 DP slave is operated with a specific telegram type:
4 axes, each with one encoder (standard telegram 3) and I/O data
Figure 4-2
SIMOTION ADI4 - Analog Drive Interface for 4 Axes
Equipment Manual, 07/2017, A5E33446849B
Telegram type
Parameter assignment
4.4 PROFIBUS parameters
45