Table of Contents
Advertisement
12/83
Bosch Rexroth AG
Important Instructions on Use
2.2
Inappropriate Use
Rexroth IndraControl VAM 11.1/41.1 Machine Control Panels
Each drive control device has to be programmed before commissioning so that
the motor executes the application-specific functions.
The VAM 11.1/VAM 41.1 were developed for the single axis as well as for the
multiple axes drive tasks and control tasks.
For the application-specific use of the VAM 11.1/VAM 41.1, device types are
available with a different drive performance and different interfaces.
For the application specific use of machine control and visualization terminals,
device types with different equipment and different interfaces are available.
Typical fields of use of the VAM 11.1/VAM 41.1 are:
●
Lathes
●
Milling machines
●
Machining centers
The devices of the VAM 11.1/VAM 41.1 design may only be operated under the
assembly conditions and installation conditions, in the specified position of ap‐
plication and under the specified ambient conditions (temperature, degree of
protection, humidity, EMC etc.) given in this documentation.
The application of VAM 11.1/VAM 41.1 that are not within the specified areas
of application or under operation conditions deviating from the operation con‐
ditions and technical data specified in the documentation is considered as
"inappropriate".
VAM 11.1/VAM 41.1 must not be used if ...
●
it is exposed to operation conditions that do not fulfill the ambient condi‐
tions specified. For instance, operation under water, in case of extreme
variations of temperature or in extreme maximum temperatures is not al‐
lowed.
●
the intended applications have not expressly been allowed by Rexroth. It
is imperative that you also note the information given in the general notes
on safety!
DOK-SUPPL*-VAM*11/41**-PR03-EN-P
Advertisement
Table of Contents
