Beckhoff KL3208 Manual page 43

R19: Manufacturer scaling - offset
This register contains the offset of the manufacturer scaling. It can be activated by R32.1 [} 43] in the
feature register.
R20: Manufacturer scaling - gain
This register contains the gain of the manufacturer scaling. It can be activated by R32.1 [} 43] in the feature
register.
R21: Offset register for two-wire connection
The value of register 1 at short circuit +R1-RL1 or +R2-RL2
R23: Reference calibration value: Offset
This register contains the reference value of the calibration, which is determined during the vendor
calibration.
R24: Reference calibration value: Gain
This register contains the reference value of the calibration, which is determined during the vendor
calibration.
R31: Code word register
• If you write values into the user registers without first entering the user code word (0x1235) into the
code word register, the terminal will not accept the supplied data.
• If you write values into the user registers and have previously entered the user code word (0x1235) in
the code word register, these values are stored in the RAM registers and in the SEEPROM registers
and are therefore retained if the terminal is restarted.
The code word is reset if the terminal is restarted.
R32: Feature register
The feature register specifies the terminal's operation mode.
Bit R32.15
Name SensorType
Bit R32.7
Name -
KL3208, KL3228/KS3228
R32.14 R32.13 R32.12
R32.6 R32.5 R32.4
- Resolution -
Version: 3.3.0
Access from the user program
R32.11 R32.10
disChannel -
R32.3 R32.2
- disWdTimer enManScal enUsrScal
R32.9 R32.8
- -
R32.1 R32.0
43