Manual Span Calibration - Fuji Electric ZPG Instruction Manual

6.8.2 Manual span calibration

sensor.
SPAN
ENT
plied.
CAUTION
For the Ch (components) in which "both" is
set in the calibration range setting (Refer to
Section 6.2.3) - span calibration is carried out
for both ranges.
ENT
Note: For the Ch (component) for which
"AR" is selected in Section 6.1.1
"Setting of range switch mode",
the cursor automatically moves to
the range selected in "Setting of
auto calibration component/range"
(Section 6.2.4), and calibration is
carried out within that range.
To close "Span Calibration"
To close the "Span Calibration" or cancel
this mode midway, press the
A previous screen will return.
INZ-TN2ZPG-E
SPAN Cal.
key and press
SPAN Cal.
SPAN Cal.
ESC
key.
75
X
Measurement mode screen
SPAN
Select Ch No.
with UP / DOWN and ENT
Back with ESC
Ch1 Range 1 0-10.00
NOx Range 2 0-100.0
Range 1 0-10.00
Ch2
Range 2 0-25.00
O
2
(
Select Ch No.
with UP / DOWN and ENT
Back with ESC
Ch1 Range 1 0-10.00
NOx Range 2 0-100.0
Range 1 0-10.00
Ch2
O Range 2 0-25.00
2
ENT
ENT : Go on calibration
of selected Ch.
ESC : Not calibration
Ch1 Range 1 0-10.00
NOx Range 2 0-100.0
Range 1 0-10.00
Ch2
Range 2 0-25.00
O
2
ENT
To Measurement screen after
executing Manual Span Calibration
ppm 0.0
ppm
vol%
vol% 20.09
ENT
)
ppm 0.0
ppm
vol%
vol% 20.09
ppm 9.8
ppm
vol%
vol% 20.09