Table of Contents
Advertisement
4. Cleaning Charging Poles
Cleaning the charging poles, as marked in the gure below, with soft cleaning
cloth or tool.
Troubleshooting
Problem
Robot suddenly stops
1
cleaning & indicator
stays in blue
Power on robot, its
2
indicator is in blue
Robot doesn't change
3
direction when it
comes up against
During charging, LED
4
indicator ashes in red
and robot beeps
LED indicator ashes in
5
red
Blue LED ashes once,
6
Red LED ashes once.
Blue LED ashes once,
7
Red LED ashes twice.
Blue LED ashes once,
8
Red LED ashes triple.
Note: If all solutions given above don't work for you, please take actions below
1. Re-set the robot by switching on the power button on the control panel.
2. If re-set action doesn't work, please send the robot to seller for repairing.
Possible Cause
Robot was picked up
Cli sensor fault
Bumper sensor fault
Robot switch might
not powered on
Battery low
Side brush get stuck
Robot bumper is not
exible enough
Robot wheel get stuck
Solution
Re-place the robot on the oor
and re-start the robot
1. Clean cli sensor
2. If solutions given above
doesn't work, send it to the
seller for repairing
Check the sensor to see if it
is covered by any object
Switch on the robot
Fully charge the battery
Put robot on at surface and
clean side brush
Loosen half circle of bumper
bottom screw
Check wheels and take out
the foreign object
www.PyleUSA.com
17
Advertisement
Table of Contents
