Water Tank & Mopping Cloth - Pure Clean PUCRC95PLUS User Manual

B. Mode1 for spot cleaning, mode 2 for auto cleaning mode 3 for edge cleaning,
mode 4 for zig-zag cleaning.
The principle of over ow water tank
Water ow out from the water tank automatically because of gravity, so please
take out the water tank after nishing cleaning.
Water Tank and Mopping Cloth Installation
1. Install mopping cloth: Stick mopping cloth on the bottom of water tank as
shown in g 1. Make sure the sticking side and mopping cloth face the
appropriate sides, and then stick the mopping cloth on its sticking side.
2. Fill water tank with water: Take out rubber plug of water tank, ll it with
water, and then put back the rubber plug tightly in position to prevent water
leakage.
3. Fix water tank on the robot: Turnover the robot, x the water tank on the
robot bottom. Make sure the bolts are rmly pressed into the xing slots.
Mop cloth
Water tank
assembly
Fig 1
14
www.PyleUSA.com
Water tank
Rubber plug
Fig 2 Fig 3