Table of Contents
Advertisement
If no operation for 15 minutes, it will turn to deep sleep and power o ,
scheduling will be canceled.) So, if you want to keep scheduling when
you're not at home, do not switch o power button of robot and charging
station, and make sure robot can return back to the charging station
when it is low power or completing cleaning.
C. If robot is charged by adapter directly (not by charging station), robot
won't accept scheduling setting.
Product Operation
Battery Charging
A. Place charging home base against the wall,
plug in adapter, and signal light on charging
home base will turn on.
Note: Put charging home base against the wall
and remove obstacles about 1 meter distance
at two sides and 2 meters ahead.
B. Turn on the power switch at the bottom side of the robot, and then display
indicator will be in gradual blue, the robot is in standby. (If no command
received, the robot will turn to sleeping mode after 30 seconds)
C. Charge the robot in either way as shown below:
a. Plug the adapter into the robot and the other end to the power socket as
below on the left;
b. Plug the adapter into the charging station, and robot in standby status,
press HOME button on remote controller to direct the robot to charging
station for charging.
Note:
a. Before charging, please always keep the power switch turning on, or else the
robot cannot be charged and the " " button indicator will have red ash and
the robot beeps.
b. When in charging, the " " button indicator will gradual in red.
c. If power switch is turned o , all the scheduled operation will be lost.
d. After fully charged, the robot will have 5 beeps. (Every charge will take no
more than 5 hours).
10
www.PyleUSA.com
A
B
Advertisement
Table of Contents
