Using Snmp V2C - Cisco FM3200 Base Installation And Configuration Manual

Figure 44. SNMP dialog (SNMP disabled)

Using SNMP v2c

To change the unit's SNMP mode to v2c and configure the unit
accordingly, do the following steps:
1. Click the
• The SNMP v2c settings dialog will be shown
(page
Figure 45. SNMP dialog (v2c selected)
2. Enter a community identity value in the
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
NOTE
By default, Cisco units are shipped from the
factory with SNMP disabled.
SNMP mode drop-down, and click the v2c option.
102)).
IMPORTANT
The same community identity value must be set for
all Cisco units in the wireless network.
(Figure 45
Community ID: field.
Page 102 of 176