Fm-Quadro; Fm-Quadro For Mesh Network-Capable Devices - Cisco FM3200 Base Installation And Configuration Manual

6.5.2. FM-QUADRO

FM-QUADRO for mesh network-capable devices

IMPORTANT
The FM-QUADRO tool is only available if the Cisco FM3200
Base is set to Mesh End mode or Bridge mode. If the unit is
set to Mesh Point mode, the -FMQuadro™ menu option will
not be available.
FM-QUADRO does not feature an integrated full-network view.
It is designed to monitor network clusters only from the level of
the connected Mesh-end device. If a Fluidity Layer-3 network
is being monitored, you must use the FM-QUADRO view of the
local Global Gateway to see the network topology between the
Global Gateway and the Mesh ends to which the Gateway is
connected. You must use the FM-QUADRO view of each Mesh
End if you want to see the topology and device handoffs within
a network cluster governed by the Mesh end.
If you need a fully integrated view of the entire network, you
must use FM Monitor as the primary network monitoring tool.
The FMQuadro window contains controls to do the following functions:
• Plot all stationary wireless devices within a network, or plot all
stationary wireless devices in a Fluidity network in relation to the
mobile wireless-equipped vehicles from which they receive relayed
traffic.
• Plot all wireless links within a network.
• Show important information about each static device, mobile device
and wireless link.
• Diagnose problems with wireless links.
• Show user-configured physical positions of all Cisco Ultra-Reliable
Wireless Backhaul components in a wireless network, against the
background of an aerial map.
IMPORTANT
For detailed information on the operational concepts that
govern Fluidity, refer to the Cisco Ultra-Reliable Wireless
Backhaul Fluidity Specifications document.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Page 70 of 176