Changing The Lan Parameters - Cisco FM3200 Base Installation And Configuration Manual

Hide thumbs Also See for FM3200 Base:

Table of Contents

Remember that all Cisco devices within a network must use the

same Prodigy version.

IMPORTANT

Prodigy 2.0 is not compatible with Prodigy 1.0. Do not

implement the two protocol versions within the same network.

If you are expanding an existing network using new Cisco

hardware components, make sure that all components are

compatible with each other by:

Option 2 is recommended if the network does not contain older

Cisco devices that are not compatible with Prodigy 2.0.

If needed, change the unit's Prodigy version by clicking the Prodigy 1.0

radio button or Prodigy 2.0 radio button.

Save the Prodigy version settings by clicking the Save button.

Alternatively, clear the settings by clicking the Reset button.

Changing the LAN parameters

The LAN Parameters box (below) contains the entry controls for local-

address setting.

Device configuration using the configurator interface

1. Upgrading all network components within the same

network to firmware version 6.5 or higher.

2. Configuring all network components within the same

network to operate using either Prodigy 1.0 or Prodigy

2.0.

Page 58 of 176

Table of Contents