I Applied Configuration Settings To The Device Using Fm Racer, But I Have Lost Connection To The Device In Fm Racer; How Do I Connect An Existing Pre-Fm Racer Device To Fm Racer - Cisco FM3200 Base Installation And Configuration Manual

DHCP server? If it was, repeat the connection, making sure the
cable remains connected to the computer and the device.
• Is the
partners.cisco.com, and the address of the RACER™ Cloud
Server? If not, check for possible DNS server misconfiguration.
• Is port 443 open in the network firewall? If not, make sure the port is
open.
8.7. I applied configuration settings to the device using FM
Racer, but I have lost connection to the device in FM Racer.
When configuration settings are successfully applied to a device in
Provisioning Mode:
• The device exits Provisioning Mode.
• DHCP is disabled for the device.
• The device is restarted using the configuration that has just been
set.
Is the device expected to be connected to the internet? If so, check the
following points:
• Do the configuration settings include the correct default gateway
address and DNS server address?
• Can the device can connect to the internet from the local subnet?
8.8. How do I connect an existing pre-FM Racer device to
FM Racer?
IMPORTANT
Please note that Cisco FM Ponte kit and FM1300 Otto
transceivers are not compatible with FM Racer.
To configure and maintain these transceivers, refer to the
Cisco Installation and Configuration manual for the
specific device.
To connect compatible Cisco devices that were purchased before FM
Racer came online, do the following steps:
1. Upgrade your device firmware to a version that supports FM
Racer.
© 2021 Cisco and/or its affiliates. All rights reserved.
local DNS server
Troubleshooting
able to resolve the
Page 157 of 176
address