Local Access And Login For Initial Configuration - Cisco FM3200 Base Installation And Configuration Manual

• By connecting a control device to the Cisco device through an
internet connection (Internet access)

6.2.1. Local access and login for initial configuration

NOTE
If your computer has a wireless WiFi card, you may have to
disable the card to avoid routing issues between the
computer's wired and wireless network interfaces.
To use the Configurator interface to access the Cisco FM3200 Base
directly, do the steps that follow:
1. Power ON the unit.
2. Wait approximately
complete.
3. Connect one end of a CAT5/6 Ethernet cable to the computer that
will be used to configure the Cisco FM3200 Base.
4. Connect the other end of the Ethernet cable to the Console LAN
port on the Cisco FM3200 Base.
5. Manually set the computer's IP address and Netmask to be
recognizable by the Cisco FM3200 Base. The correct settings are
as follows:
• IP address: 192.168.0.10 (or any other IP address
belonging to subnet 192.168.0.0/255.255.255.0)
• Netmask: 255.255.255.0
6. Launch the computer's web browser.
7. Enter the IP address of the Cisco FM3200 Base in the browser's
URL entry field.
• If the Configurator interface is shown immediately, proceed
to
• Alternatively, you may see the following window:
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
one minute
Step 9 below.
for the boot sequence to
Page 43 of 176