Cisco FM3200 Base Installation And Configuration Manual page 97

• Cell A2 of the *.CSV file would contain the parameter
5.29.252.213, 5.2.22.136
Figure 39. Sample Block list (Example 3)
6. Save and close the *.CSV file.
To upload a Pass list or Block list using the Configurator interface, do the
following steps:
1. Click the –pass list / Block list link under ADVANCED
SETTINGS in the left-hand settings menu.
Figure 40. Configurator (Pass list / Block list dialog)
• The Pass list / Block list dialog will be shown
(page
2. Choose the type of list to be uploaded by clicking the correct List
Type: radio button.
3. Click the Choose File button. Upload the saved *.CSV file using
the upload dialog.
• The contents of the uploaded *.CSV file will be shown in
the Pass list / Block list Status section.
To apply the list settings contained in the *.CSV file, click the Apply
Settings button.
To clear the Pass list or Block list settings without deleting the *.CSV file,
click the Clear Pass list or Block list button.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
97)).
(Figure 40
Page 97 of 176