Cisco FM3200 Base Installation And Configuration Manual page 73

• The device label, corresponding to the device's name
configuration parameter (Alexa in the image above).
• If the device is a mobile radio transceiver, the device's
Primary/Subordinate setting will be shown. A Primary
device is marked M, and a Subordinate device is marked S.
• The device's IP address.
• If the device is a stationary mesh end, it will be marked ME. If
it is a stationary mesh point, it will be marked MP. If it is a
mobile radio, the RSSI (in dBm) between the radio and the
stationary radio to which it is connected will be shown.
• If the device does not currently have a configured IP address
or device label, the device's Cisco Mesh ID number willbe
shown.
• If the network is a Fluidity network, mobile Cisco radio
transceivers that are part of the network are shown as
tooltips with colored borders. The tooltip representing a
mobile Cisco radio is always shown below the tooltip of
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
• The icon below will be shown if the device is a
stationary radiodevice that is part of a Fluidity network:
• The dynamic Wi-Fi reception-style icon below will be
shown if the radio device is a mobile device that is part
of a Fluidity network. This icon shows whether the
radio's current RSSI is weak, acceptable or strong.
• The icon below will be shown if the device is an Ultra-
reliable Wireless Backhaul Gateway device.
Page 73 of 176