Installation - Kohler 24270T-CP Installation Instructions Manual

Oblo sensor faucet
Table of Contents

Advertisement

技术参数
电源:直流 4节5号碱性电池(LR06×4)
交流 电压220V,频率50/60Hz
检测时间:小于0.75秒
关阀延时:0.5~2秒
感应距离:自动调节
流量:
0.5GPM
约1.9L/min
0.35GPM
约1.4L/min
0.26GPM
约1.0L/min
超时用水控制:超时用水1分钟,自动止水。
环境温度: 1 ~ 55
进水温度:0.5~ 71
适用水压:0.05~
一 如何安装水龙头
1.龙头与面盆的安装固定
将固定螺杆(2)安装到水龙头底部(3)
处。再把垫片(4)套在固定螺杆上。并
嵌入水龙头底部的盘槽中。然后将电
源线(8)和进水软管(9)穿过安装孔,
从面盆下方将固定橡胶垫片(5)固定金
属垫片(6)和固定螺母(7)对齐固定螺
杆(2)向上套入。调整水龙头电源线
(8)及进水软管(9)的位置。用扳手拧
紧固定螺母(7)以便把水龙头固定在面
盆上。
二 安装阀体组件
关闭角阀(12),
对于冷热混水型的阀体组件安装是先
将三通进水软管组件的两端与角阀
(12)连接,然后把阀体组件(10)进水
口处的保护帽旋出,将阀体组件(10)
进水口与三通进水软管组件(11)连
接;对于单冷型的阀体组件安装是把
阀体组件(10)进水口处的保护帽旋
出,将主阀体组件(10)进水口与角阀
(12)连接。
4
PARAMETERS
Power: DC 4 pieces of AA size alkaline batteries
AC 220V, 50/60Hz
Senser Duration: Less than 0.75s
Shut-off Delay: 0.5~2s
Sensing Distance: Automatic adjustment
Flow Rate:
0.5GPM
0.35GPM About 1.4L/min
0.26GPM About 1.0L/min
Overtime Flowing Control: Automatically stop flushing when
the faucet senses an object for more than 1 minute
continuously
Ambient Temperature: 1~55
Supply Water Temperature: 0.5~71
Supply Water Pressure: 0.05~0.86MPa
2
3
5
4
7
6
8
9
10
11
12
9
10
12
About 1.9L/min

INSTALLATION

How to Install the Faucet
1. Fixing the faucet and lavatory
Install the mounting stud (2) to the bottom
of the faucet (3), then slip the washer (4)
over the mounting stud and put them into
the groove on the spout. Insert the power
wire (8) and supply hose (9) into the hole
from underside of the lavatory. From
underside of the lavatory, slide the rubber
washer (5), meter washer (6) and fixed
nut (7) onto the mounting stud (2).
Tighten nut (7) to make faucet installed on
the lavatory.
2. Install alve Assemly
Turn valve off (12).
For mixing water valve assembly
installation, connect water inlet hose
assembly to both ends of stop valve (12),
then unscrew valve assembly (10) water
inlet protection cap, connect valve
assembly (10) inlet to Tee water inlet
hose assembly (11); for cold water faucet
installation, unscrew valve assembly (10)
water inlet protection cap, connect valve
assembly (10) inlet to valve (12).
1364728-T01-A

Advertisement

Table of Contents
loading

This manual is also suitable for:

24271t-cp24270t-s3-cp24270t-s5-cp

Table of Contents