Table of Contents
Advertisement
使用说明
1. 手伸到出水口下方感应范围
内（感应距离随面盆、周围的情
况而自动调节），水龙头出水。
手离，0.5～2秒后，水龙头自动
止水。
2. 冷热混水龙头水温调节：先关
闭热水角阀，再将冷水角阀旋至
冷水最大状态，再缓慢打开热水
角阀，以免烫伤。如冷水水压
大，打开全部热水角阀后，仍无
合适水温，请再缓慢减少冷水出
水量，直至水温使用舒适。
注意：
请勿将龙头安装在台面上，
同时搭配台上盆。
2
OPERATION INSTRUCTIONS
1. Put your hand in the sensing -range, the
faucet should turn on. The faucet should turn
off after removal within 0.5~2 seconds. The
sensing distance will be adjusted automatically
as per the condition of the lavatory and
surrounding environment.
2. Adjust the water temp for faucet with
temperature mixture: turn off hot water valve
first, and then turn on the water and adjust to
full cold, slowly turn on hot water valve to
avoid scalding. If cold water pressure is high
and unable to gain proper comfortable water
temp even hot water valve is fully open, turn
down cold water capacity slowly until water
temp is comfortable for use.
Note:
please do not install the faucet on the
table and match the washbasin
1364728-T01-A
Advertisement
Table of Contents
