Table of Contents
Advertisement
3. 清洗过滤系统
该感应龙头的阀体组件内已包含了优良的过滤装
置。如管内杂质过多或水质较差，长期使用会引
起出水情况不良。请按以下步骤清洗过滤装置：
(1) 关闭角阀。
(2) 将主阀体组件取下，拿出滤网，用水冲洗完
毕后，重新装入。
注意：在清洗完滤网后，不要遗失平垫。
4. 自动清洗存水功能
感应龙头长期处于不使用状态时，每间隔24小
时自动冲水一段时间排出龙头内的存水。
10
3. Clean the Filtration System
The faucet includes connector assembly with high quality
filtration system. If there is a lot of debris in the supply pipes
or the quality of water is bad, it will cause the flow in bad
condition. Please clean th filtration system as following steps:
(1) Close the angle valve.
(2) Remove the valve assembly and take out the filter for
cleaning, then re-install it.
Notice: Make sure to install the filter washer after cleaning
the filter
4. Self-Cleaning the stagnant water
When the faucet is no used for a long period of time, it will
automatically flush to discharge the stagnant water inside
the faucet every 24hrs.
1364728-T01-A
Advertisement
Table of Contents
