Table of Contents
Advertisement
1.电源盒 (背面有不干胶)应安装在干燥，不会被水
淋湿、浸泡的位置。根据需要客户自备穿线管及
连接线。穿线管安装在墙内。建议交流电源线采用
带绝缘和护套层的电线，导体标称截面积 0.5mm ;
直流连接线采用导体标称截面积
请严格按照上图进行连接。
2. 排线完毕后，应检查并确保所有排、接线无误，
再分别连接电源盒AC接线端与排线管内交流接线
端，以及电源盒DC接线端（黑橙线接头）与龙头
的电源线接插件（从阀盒内引出的电线），最后
打开AC电源，龙头进入30秒自动调距阶段，此过
程龙头不会出水。
1364728-T01-A
1. Install AC power unit (sticker on the back) dry, and avoid
showering, soaking from water. Customer prepare wire
tube and wire according to requirement. Wire tube
should be put into the wall. Suggested wire: AC connection
2
wire should with insulated protecting layer or sleeve and
2
0.3
mm 的电线。
the section should be bigger than 0.5mm . The section of
DC connection wire should be
connection pattern must according to illustrations above.
2. After wire layout finished, check and repair if needed.
Then connect AC connector of AC/DC transformer to
electrical source from the control box, and DC connector of
AC/DC transformer to faucet. Turn on AC electrical power,
Faucet will commence auto-sense mode which will take
30s. The faucet will not work this period.
2
2
bigger than 0.3mm . The
7
Advertisement
Table of Contents
