Used Standards; Fig. 4-9: Used Standards - Bosch Rexroth IndraControl VEH 30.1 Project Planning Manual

IndraControl VEH 30.1
4.9

Used Standards

UL/CSA Certification
DOK-SUPPL*-VEH*30.1***-PR02-EN-P
The system components
IndraControl VEH 30.1 correspond to the following standards:
Standard
EN 50178
EN 60 204-1
EN 50 081-2
EN 50 082-2
EN 60 742
EN 60 950
EN 61 131
EN 61 131-2
EN 418
EN 60 529
EN 60 068-2-6
EN 60 068-2-32
EN 60 068-2-27
Fig. 4-9: Used standards
The IndraControl VEH 30.1 device is certified according to
• UL508 (Industrial Control Equipment) and
• C22.2 No. 142-M1987 (CSA)
However, it is possible that there are combinations or extension stages
with restricted or missing certification. Thus, verify the registration
according to the UL marking on the device.
Note: To guarantee an UL/CSA-compliant operation, you have to
fulfill the following conditions:
• Use 60/75 °C copper wire only.
• All connections are to be protected by a 2 A time-lag fusible
cut-out.
Note: The UL/CSA marking is only valid for the device in its delivery
status. After having modified the device the UL compliancy
has to be verified.
of the
Meaning
Equipment for use in power installations
Electrical equipment of machines
Basic technical standard, emitted interference
(industrial environment)
Basic technical standard, noise immunity (industrial
environment)
Transformer for 24 V power supply unit, protective
separation
Overvoltage category II
Requirements concerning the 24 V outputs
Requirements concerning the 24 power supply
Machine safety, EMERGENCY STOP devices
Degrees of protection (incl. housings and installation
compartments)
Vibration test
Free fall test
Shock test
4-5
Technical Data
embedded terminal